Monday, October 28, 2013

ATP Inter Cooler Install 13' F150 EcoBoost

ATP Inter Cooler Install 13' F150 EcoBoost


Want lower intake temps while towing?  We installed the ATP IC on our Tow Heavy Eco Boost F150 truck for the added benefits of reduced inlet intake temps while pushing the max limits our the Eco Boost motor.  If you tow heavy then this added with the AFE charge pipe and Perf/Tow tune are a great combination.














Sunday, July 21, 2013

NEW! Introducing 5 Stars new F150 2wd 3.7L v6 Eco Pack

Want more fuel economy without the sacrifice of drive-ability and good power? The issue with the 2011-2013  3.7L v6 F150 in both Crew Cab and Supercab models the only gear set you can get from Ford is the 3.73 gear, not a bad gear at all but for highway use and speeds of 40-75 mph it is not the best fuel efficiency gear.

The solution is to install a more efficient gear set like a Ford Racing 3.15 gear. With this gear installed Engine RPMs are dropped approx 300-400 rpm in all forward transmission gears. This helps with highway fuel efficiency and as a side benefit reduces cabin noise at highway speeds. The new provided tune/map; the speedometer is corrected and the shift and torque converter patterns are remapped to keep the same feel for hp/tq while driving, its the best of both worlds. The tune/map will provide more low end tq and hp and 4th , 5th and 6th transmission gears become more useful with this new 3.15 gear.  As an example 6th gear comes in now at 50 mph vs 39 mph, that means 5th gear comes in later as well. Tow capacity will be slightly reduced to 5000 lbs approx but if you're the occasional tower this is of no concern.. We see a consistent 2 mpg gain over stock 3.73 gears set on our own F150 3.7L, obviously results will vary based on vehicle, driver and terrain.

The Eco Pack contains:New 3015 X3 device with 4 custom tunes; 87 Economy, 87 Economy Sport (more torquey), 91 Economy, 91 Economy Sport (more torquey) and New Ford Racing 3.15 Gear.


Sunday, June 30, 2013

5 Star Raptor with Stainless Works Headers and Custom 4 inch Exhaust

Our 2011 Raptor has stainless works headers with the LMF s tube muffler exhaust, one of the best sounding systems and is great when you want a loud bite but a little loud in the cab if your on the phone like me; So we decided to change it up a bit and do something different. We have worked with the eco boost F150 V6 a lot on different exhaust and finding one that most can live with no drone and noise is a long chore. So we took what we learned on it and added 4 inch cab back exhaust to the Raptor with 2 4" twister resonators one before and one after the muffler; now its sounds like a big block with little to no drone in cab. Very pleased with sound so we thought we would share the recipe





SOME VIDEOS



Tuesday, January 15, 2013

5 Star Installs and Dyno's Stainless Works F150 Ecoboost Exhaust System

5 Star Installs and Dyno's Stainless Works F150 Ecoboost Exhaust System Cat Back & Down Pipe with Cats.